Changeover Time is Coming

After one of the coldest winters in recent memory, the heating to cooling changeover is right around the corner. Here are some tips for making the changeover this year.

 

1)      During the shoulder season when heating may be required, Make Up Air units that are fed by Primary Boilers can be left in a heating mode while the fan-coils in the suites are switched over to cooling. With a cooler Spring appearing likely, this will allow you to provide some heat in the corridors while providing cooling insuite.

 

2)      Glycol – make sure that when draining coils of glycol to recover all of the glycol in clean storage containers. Do not let the glycol flow into the building mains.

 

3)      Basement Loops (Miscellaneous Heating Loops) that are fed from the Heating / Cooling Mains need to be manually shut down during the summer to prevent condensation in enclosed spaces.

 

4)      Do an inspection of the Cooling Tower well before your changeover date. With the ice storm, it is possible that parts of the Tower may have experienced some damage due to heavy ice.

 

5)      Make sure that outside, electrically heated areas are shut down for the summer or that the controlling thermostats are set to a minimum set-point a couple of degrees above freezing.

 

6)      Remember to call Provident Energy during your changeover. Unless the Energy Management System is commanded to the cooling mode, HVAC systems will not operate properly.

SpringFest 2014

SpringFest 2014 is less than a month away!

The annual educational seminar and tradeshow expo will take place Thursday April 10 at the Metro Toronto Convention Centre – South Building. Be sure to drop by and see us at Booth #318! For more information, including FREE registration, please visit their website. http://www.springfesttoronto.com

Tech Corner – Even Buildings Need Exercise!

In operating a building, there is a phrase that is often used – “exercise the valve”. What does this mean? It simply means to operate a valve to check for proper operation. Over the last year, we have had a number of instances remind us of why exercising valves is important.

In one case, as part of an overall building improvement program, all of the gas lines in the building were re-painted yellow, the colour indicating a natural gas line. It looked great. However, when we went to exercise the emergency gas shut-off valves, we discovered that the valve had been painted as well, and the valve was well and truly stuck in the open position. Fortunately this was discovered during a routine inspection and corrected. Imagine if this had been the case during an emergency!

In another case, we operated some needle valves on the Domestic Cold Water Booster Pumps in order to do some testing. These valves had not been exercised in years. The result was a failure of the Low Suction Pressure Limit on the system and resulted in a loss of water in the building for a number of hours.

There have been countless cases over the years where work has been delayed or re-scheduled because isolation valves that were supposed to allow work to be done on the plumbing systems did not “hold” (work as designed and “hold” back the water).

Exercising valves is a good maintenance practice and should be done on a regular basis. It only takes a few minutes to exercise a valve, but it can mean hours or days on a job when it is suddenly discovered that these valves don’t work.

The same “exercising” principal can be applied to lead / lag equipment. For example, a pump system may be set up where if the lead pump fails, the lag (or back-up) pump will kick on. If the lag pump is not exercised periodically, the seals on the pump can deteriorate, ‘dead-spots’ in motor windings can develop, and couplings can fail when first started.

A good building exercise program begins with a list of priority valves in the building. These include, main water shut off, gas valves, riser isolation valves, and builds from there. A little exercise can go a long way.